CADDX Ranger 9000E - Code Management and System Testing; Changing the Master Code; Programming Auxiliary Codes; Removing Auxiliary Codes

CHANGING THE MASTER CODE The master code is user code and must be
programmed by referring to its code. For example, if the Master code is and you
want to change it to the sequence would be as follows. Press (this
enters programming for user Then press (old Master code) followed by the
new master code The entire sequence would consist of pressing 11 keys as
follows:
PROGRAMMING AUXILIARY CODES In order to program Auxiliary Codes you must know
the Master code. As stated earlier, each auxiliary code has its own unique number from
to and must be referred to by its number. It is programmed much like the Master Code.
For example, to program Auxiliary user code
the sequence would be as follows:
1 1 1
REMOVING AUXILIARY CODES To remove an Auxiliary user code, simply program that
code as
For example, to remove user code the sequence would be as
follows:
TESTING YOUR SECURITY SYSTEM
There are several tests you should perform on a periodic basis (at least once a week) to insure
that your Security System is functioning properly.
Enable “THE CHIME” feature and open all protected windows and doors. The
Keypad Control should sound (beep) for each device and the appropriate yellow
zone light should blink.
Walk into all areas protected by motion detection devices while someone observes
the Keypad Control. The appropriate yellow zone light should blink for each sensor
tested.
l
If your system has a “FIRE” zone, the Smoke or Heat detectors should be tested at
least monthly. If your Security System is monitored by a Central Monitoring Station,
always call beforehand to let them know that you are about to conduct a test of the
fire detection system. Always call after the test to ask for results and to put your fire
detection system back into service.
If the Siren/Bell test option has been selected by your installing company, you may
activate the siren/bell by pressing the one [I
and keys at the same time for one
second. To silence the siren/bell, enter your 4-digit master or auxiliary code.
IF ANY OF THE ABOVE TESTS ARE NOT SUCCESSFUL OR THE RESULTS UNCLEAR,
CONTACT YOUR SERVICE COMPANY AT THE PHONE NUMBER LISTED ON PAGE 1 OF
THIS SYSTEM HAS BEEN LISTED BY UNDERWRITERS LABORATORIES FOR GRADE
A LOCAL, GRADE B
C CENTRAL STATION, POLICE CONNECT WITH BASIC LINE
SECURITY, GRADE A HOUSEHOLD BURGLARY
HOUSEHOLD FIRE.