EasyManua.ls Logo

Cadillac 1996 Eldorado - Page 142

Cadillac 1996 Eldorado
354 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGINE COOLANT HOT-IDLE ENGINE
-
44:
This message will appear when the engine coolant
temperature is over
248
OF
(126°C). To avoid added
strain on a hot engine, turn off the climate control
system. Stop and allow your vehicle to idle until it cools
down or
the
message is removed. If it does not cool
down, turn off the engine and have it serviced before
driving it again. Severe engine damage can result from
an overheated engine. See “Engine Overheating” in
the Index.
FUEL LEVEL VERY LOW
-
11:
This message serves
as a warning that the fuel level in the tank is critically
low. Stop for fuel immediately.
MONITORED SYSTEMS OK
-
1:
This message only
appears in the “recall” mode by pressing the RESET
button. It lets you know that no other messages are
stored or currently active.
PASS
KEY
NOT
PROGRAMMED
-
31:
This
warning message displays when the PASS-Key pellet
information has not been programmed into your vehicle.
See your Cadillac dealership for service.
PCM
FAULT
-
110:
The circuit in the Powertrain
Control Module (PCM) has shorted or is loose when this
message appears. Have your Cadillac serviced by your
dealership at once.
REDUCED ENGINE POWER
-
41:
This message
informs the driver that due to wheel slippage your
vehicle is reducing engine power to compensate for the
loss of traction. Accelerating too fast causing the tires to
spin is an example of when this message would display.
REMOVE KEY
-
70:
This message will appear when
the Personalized Automotive Security System
(PASS-Key
11)
is unable to read the pellet on the
ignition key or an improper key pellet has been inserted.
Wait for the DIC to display STARTING DISABLED
DUE
TO THEFT SYSTEM REMOVE IGNITION
KEY. The instrument panel cluster will then run a timer
and change the messages to WAIT
3
MINUTES, WAIT
2
MINUTES,
WAIT
1
MINUTE
and then START
CAR.
When the REMOVE KEY message is displayed, remove
the ignition key. Check the ignition key for damage.
If
it
is damaged,
it
may need to be replaced.
If
you see no
damage, clean the pellet contacts with a soft cloth or
2-81

Table of Contents

Related product manuals