Care
af
Safety
Belts
Keep belts clean and dry.
A
CAUTION:
Do
not bleach or dye safety belts.
If
you do, it
may severely weaken them.
In
a crash they might
not be able to provide adequate protection.
Clean safety belts only with mild
soap
and
lukewarm water.
Glass
Glass should be cleaned often.
GM
Glass Cleaner
(GM
Part
No.
1050427)
or
a
liquid household glass cleaner
will remove normal tobacco smoke and dust films.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on the inside rear
window, since they may have to be scraped
off
later.
If
abrasive cleaners are used on
the
inside
of
the
rear
window, an electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.
Cleaning
the
Outside
of
the
Windshield and
Wiper
Blades
If
the windshield is not clear after using the windshield
washer, or
if
the wiper blade chatters when running, wax
or
other material may be on the blade or windshield.
Clean the outside of the windshield with
GM
Windshield Cleaner, Bon-Ami Powder@
(GM
Part
No.
105001
1).
The windshield is clean
if
beads do not
form when you rinse it with water.
Clean the blade by wiping vigorously with a cloth
soaked in full-strength windshield washer solvent. Then
rinse the blade
with
water.
Wiper blades should be checked on a regular basis and
replaced when worn.
Weatherstrips
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease
with
a clean cloth at least every six
months. During very cold, damp weather more frequent
application may be required. (See “Recommended Fluids
and Lubricants’’
in
the Maintenance Schedule booklet.)
6-48
To Next Page
Loading...
