remain in a “high park” position, even when the ignition
is turned
OFF.
The Rainsense wipers operate in a delay mode as well
as, a continuous low or high speed depending on the
amount of moisture and
the
sensitivity level. The
MIST
and “wash” cycles operate as normal and are not
effected by the Rainsense function.
NOTICE:
The Rainsense feature should be turned off when
going through a car wash to avoid damage.
It
is
important
to
note that
the
Rainsense wiping feature
(AUTO
DELAY)
can be overridden at any time by
manually changing the wiper control to
LO
or
HI speed.
Note that if
you
ever need to replace the windshield,
make sure
it
is Rainsensor compatible.
Windshield
Washer
In freezing weather, don’t use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice
on
the windshield, blocking
your vision.
Press and hold the
PUSH
paddle
to
wash the windshield
Release the paddle when you have enough fluid. The
wipers
will
clear the windshield and either stop
or
return
to
your
preset speed.
LOW
WASHER
FLUID
will
be displayed on the DIC
when the washer fluid reaches a low level.
Driving without washer fluid can be dangerous.
A
bad
mud splash can block your vision and you could hit
another vehicle
or
go
off
the road. Check the washer
fluid
level often.
2-34
-
To Next Page
Loading...
