The TEMP knob adjusts the air temperature coming
through the system.
Turn
the TEMP knob clockwise to
increase the temperature and counterclockwise
to
decrease the temperature. The outside temperature
is
always displayed when your vehicle is running.
Modt
:ton
Press this button to deliver air through the floor, middle
or windshield outlets. The system will stay
in
the
selected mode until the
MODE
button is pushed again.
Press the up or down arrow to cycle through the
available modes.
When the system is set for AUTO, sensors will control
the air delivery mode. Air will come from the floor,
middle or windshield outlets. The fan speed will vary
as
the system maintains the selected temperature setting.
Be careful
not
to put anything over the solar sensor
located in the middle of
the
instrument panel near
the
windshield. This sensor
is
used by the automatic system
to regulate temperature.
To find your comfort zone, start with
75°F
(24°C)
setting, allow about
20
minutes for the system
to
regulate. Press
the
red or blue temperature buttons
to
adjust the temperature
if
necessary.
If
you choose
60°F
(16"C), the system will remain at that maximum cooling
setting and will not regulate fan speed.
If
you choose
the
temperature of
90°F
(32"C), the system will remain at
that maximum heating setting and will not regulate fan
speed. Choosing either lnaximum setting will not cause
the system to heat or cool any faster.
With this setting, the air conditioning compressor
automatically cycles when needed to cool the air.
In
cold
weather, when the system senses the need for heat, the
airflow will be directed out the floor outlets.
As
the
interior temperature approaches a desired setting, the
blower speed will decrease.
To
maintain interior
comfort, the airflow may move to the instrument panel
air outlets and floor outlets (BI-LEVEL mode). On
bright, sunny days in cold weather, the airflow may
come out of the
A/C
outlets (AC mode)
to
maintain
comfort and prevent stuffiness.
If your vehicle is sitting out
on
a hot day and
you
have it
set
on
AUTO,
the
air
will
first flow out the
floor
air
outlets for a few seconds. That is normal. This is
to
expel hot air
in
the air outlets. As the air is cooled, the
airflow will move through the A/C outlets. If you start
your vehicle
with
the fan setting
on
HI
it
will skip the
A/C Purge.
To Next Page
Loading...
