sf
FAN
SPEEDS:
Press the button with
the
fan
symbol until AUTO is displayed on the screen. At this
setting, the fan speed is automatically controlled. If
it
is
cold outside, the blower may not run in the maximum
high fan speed right away.
The
system checks
the
temperature of the engine coolant to assure
it
is
warm
enough
to
provide heat. When the engine coolant is
warm, the controller allows the fan to gradually increase
to
a higher speed. This prevents cold air from blowing
into the passenger compartment.
If
you want the blower
fan at a high speed, press the up arrow button until you
see
HIGH
on the display. If you want the fan speed
to
be
automatic, but you like the
fm
speed
to
be higher than
the AUTO setting, press the fan symbol button until
HIGH
AUTO
is
shown on the display. If you want the
blower fan at a low speed, press the down arrow button
until
LOW
is shown on the display.
If
you want
the
fan
speed to run lower than the AUTO setting, press the
button until
LOW
AUTO is shown on the display.
OFF:
Press this button to turn
the
system off. Fresh
air will continue
to
flow through the vehicle, and
the
system will try to maintain the previously set
temperature. The outside temperature will show
on
the display when the system is
OFF.
AC:
Press this button to turn the air conditioning on and
off.
The system will cool and dehumidify the air inside
the vehicle. In the AUTO mode, the display will show
that AC is active, but the air conditioning compressor
only operates when the system determines
it
is needed.
RECIRCULATION:
Press this button to limit the
amount
of
fresh air entering your vehicle. This
is
helpful
when you are trying to cool the air quickly or limit odors
entering your vehicle. In the AUTO mode, the system
will use recirculation as necessary
to
cool
the air.
Pressing the recirculation button will change the
operation to
a manual mode and the air will recirculate
non-stop. Press this button again to turn
off
the
recirculation feature.
If
you notice the windows fogging, press
the
recirculation button to exit the recirculation mode.
DUAL TEMPERATURE
CONTROL:
With
this feature, the right front passenger can control the
temperature of heated air for his/her own zone. The
passenger can select
a four degree warmer or cooler
temperature from the driver's setting.
To
turn the system
on,
press the
PASS/TEMP
button. Press the up arrow
to increase the temperature and press the down arrow
to
decrease the climate setting. Pressing the
OFF
button
will turn
off
the dual-zone Function.