The power seat controls are located on the outboard side
of the front seat cushion.
0
Move the front of the control in the direction of the
arrows to adjust the front portion
of
the cushion up
or down.
Move the rear
of
the control in the direction of the
arrows to adjust the rear portion of the cushion
up
or
down.
0
Lift up or push down on both outer arrows at the
same time to move the entire seat up or down.
Power
Lumbar
Control
(Option)
The lumbar control
is
located on the outboard side
of
each front seat. After you
have made your desired
seating adjustments, move
the lumbar control to the
maximum up and out
To
move the whole seat forward or backward, slide
the control in the direction of the center arrow.
To do this, press the control forward to increase support
and upward to raise the support mechanism.
To
adjust
the
back support, press
the
control down and rearward.
Keep
in
mind that as your seating position changes, as
it
may during long trips,
so
should the position
of
your
lumbar support. Adjust the seat as needed.
1-2
To Next Page
Loading...
