125 . . .
–
Section 1
High-Low Beam Control
When the headlights are turned
on and the lever is in the center
position, the headlights are set to
low beams.
To change the lights from low
beams to high beams, push the
lever toward the front of the
vehicle. To change the lights back
to low beams, pull the lever back
toward you. When the high beams
are on, an indicator light on the
instrument cluster will also be on.
Headlight High Beam Flashing
You may be able to flash your high
beams to signal other drivers when
the low-beam headlights are on.
To do this, pull and hold the lever
toward you as long as you want
the high beams to be on. Release it
to turn the high beams off.
Windshield Wipers
NOTICE
Clear any ice or snow from the
wiper blades before using them
to prevent damage to the
blades and overloading the
wiper motor.
Rotate the band to turn on the
wipers.
For a single wiping cycle, rotate
the band to the "mist" setting .
$10araEscaladeEXT Page 125 Wednesday, October 14, 2009 9:54 AM
To Next Page
Loading...
