Starting and Operating Instructions
. . . 246
Engine Starting
Make sure the parking brake is
applied before starting the engine.
To start, the gear selector must be
in P (Park) or N (Neutral).
Use N (Neutral) to restart when
the vehicle is already moving.
NOTICE
Do not shift into P (Park) while
the vehicle is moving.
Otherwise, the transmission
could be damaged.
Turn your ignition key to START.
Do not push the accelerator pedal.
Let go of the key when the engine
starts. The idle speed will go down
as the engine gets warm.
If the engine does not start within
15 seconds, the system will stop
cranking the engine to prevent
starter motor gear damage.
Do not race the engine
immediately after starting.
Allow enough time for the engine
to warm up and deliver oil to the
various parts of the engine
requiring lubrication.
Vehicle Remote-Start
This feature allows you to start the
engine from outside the vehicle.
See the following for more
information:
• Remote Keyless Entry
-Vehicle Remote-Start
Computer Controlled
Cranking System
This feature helps start the engine
and protects components. Once
cranking is initiated, the engine
will continue to crank for a few
seconds or until the vehicle starts.
If the engine does not start within
15 seconds, the system will stop
cranking the engine to prevent
starter motor gear damage.
Turn the ignition to the ACC or
LOCK position to stop cranking
and turn the engine off.
$10araEscaladeEXT Page 246 Wednesday, October 14, 2009 9:54 AM
To Next Page
Loading...
