133 . . .
–
Section 1
If a mirror ever becomes disen-
gaged, it will need to be reset.
To reset a mirror, fold and unfold it
using the power controls.
You may hear a momentary motor
or clicking noise. This is normal.
MEMORY SEAT, MIRRORS,
STEERING COLUMN AND
ADJUSTABLE PEDALS
This feature allows two different
drivers (driver number 1 or driver
number 2) to store and recall
their own driver's seat positions
(including recliner and lumbar
adjustment), outside mirror
positions, steering wheel and
adjustable pedal positions.
The controls are located on the
driver’s door panel.
See "Memory Feature" later in this
section for more information.
CURB VIEW ASSIST MIRROR
With this feature turned on, the
passenger's and/or driver's mirror
will tilt down whenever the vehicle
is shifted into R (Reverse) to a
pre-programmed position,
allowing you to view the curb
while you parallel park. If further
adjustment is needed, use the
power mirror switch.
A few seconds after you shift back
out of R (Reverse) or if you turn off
the ignition, the mirrors will return
to their original position.
Use the Driver Information Center
to enable or disable this feature.
See the following under "Driver
Information Center" earlier in this
section for more information:
• Feature Customization
- PARK TILT MIRRORS (park
tilt mirrors)
$10araEscaladeEXT Page 133 Wednesday, October 14, 2009 9:54 AM
To Next Page
Loading...
