Instrumentation and Controls
. . . 52
• PRESS TO CHANGE
COMPASS ZONE (press to
change compass zone)
Note: This feature may not be
available on all vehicles.
Your vehicle’s compass should
be pre-set to your zone.
If your vehicle is taken outside
this zone, it may be necessary
to adjust the compass to
compensate for variance.
See "Compass" later in this sec-
tion for compass information.
• PRESS TO CALIBRATE
COMPASS (press to
calibrate compass)
Note: This feature may not be
available on all vehicles.
With the ignition on, the
compass reading will appear in
the driver information center
display.
If CAL appears in the Driver
Information Center display, the
compass needs calibration.
If an incorrect reading is
displayed, first check that the
compass is set to the correct
variance zone. If it is, the
compass may need calibration.
See "Compass" later in this sec-
tion for compass information.
$10araEscaladeEXT Page 52 Wednesday, October 14, 2009 9:54 AM
To Next Page
Loading...
