68 — Q
UALIFIER
P
LUS
®
III
X
Default Settings
Performing a total Reset (see below) will return the calculator to the
following default settings:
• Two Fixed Decimal Places
• 12 Periods per Year = Reset to 12 Upon O
• Property Tax/Insurance = Values Cleared Upon O
• Mortgage Insurance. = Values Cleared Upon o o
• Amortization Range = Specified Year (Ent-Ent)
• Qualifying Ratios Displayed 1st
• Month Offset to January (1)
• Tax Bracket = 28%
• Qual 1 Ratios = 28%-36%
• Qual 2 Ratios = 29%-41%
• Combo Loan 1st:2nd LTV = 80%:10%; 80%:15%
Reset
Manual Reset
If your calculator’s display should ever freeze or “lock up,” press
Reset — a small hole located to the left of the O key — to perform
a total reset. (It is recommended you use a straightened paper clip,
as the hole is extremely small).
Keystroke Reset — Returning the Calculator to its Original
Factory Settings
You may at times want to reset your calculator to its factory settings
(i.e., reset all registers and Preference Settings to their original
default values). To do this, turn off the calculator, hold down the x
key, and then turn it back on.
Error Codes
With an incorrect entry or answer beyond the range of the calculator,
the display will show one of the following error messages. To clear
an error, simply press any key.
OFLO — Number Too Large to Display
DIV Error — Attempted to Divide by Zero
TVM Error — Time-Value-of-Money Error
ENT Error — Invalid Entry
PPY Error — Payments Per Year Error
QL Error — Qualifying Error
APPENDIX
To Next Page
Loading...
Need help?
General
