Calculated Industries 4054 - Page 9

P
OCKET REFERENCE GUIDE — 5
a Dimension 9 i p
an Angle 3 0 p
a Ratio 0 • 7 5 Ç p
a Percentage 7 5 % p
A Pitch entry will remain in
permanent storage until
revised or reset. A solution
will be replaced by its
entered value once the
calculator is cleared.
Ç p Enters Pitch Ratio (e.g., •
5 8 3 Ç p).
r Rise Key — Enters or cal-
culates the Rise or vertical
leg (height) of a Right
Triangle.
R Run Key — Enters or cal-
culates the Run or horizon-
tal leg (base) of a Right
Triangle.
d Diagonal Key — Enters or
calculates the common or
Diagonal leg (Hypotenuse)
of a Right Triangle. Typical
applications are “squaring”
slabs or finding common
rafter lengths.
H Hip/Valley Key —
Calculates length of the
Regular or Irregular Hip/
Valley rafter.