Fractional Settings
When your calculator is in a default
condition (battery change or full re s e t ) ,
it is set to round fractional values to the
n e a rest 1/64th of an inch. However,
you may program your pre f e rence for
six diff e rent accuracy levels and two
d i ff e rent modes (Normal and Fixed), all
of which remain in permanent memo-
ry until revised or reset.
The fractional level can be revised by
using [C O N V] as shown below:
[CONV] 1 = Fraction Set to 1/16
[CONV] 2 = Fraction Set to 1/2
[CONV] 3 = Fraction Set to 1/32
[CONV] 4 = Fraction Set to 1/4
[CONV] 6 = Fraction Set to 1/64
[CONV] 8 = Fraction Set to 1/8
If there is a value in the display, the accu-
racy level will be temporarily revised. If
the display is cleared, then the accuracy
will be permanently re v i s e d .
U s e r ’s Guide – 1 5
To Next Page
Loading...
