Entering Dimensions & U n i t s
When entering feet-inch dimensional
values, you must enter the largest d i m e n-
sion first — feet before inches, inches
b e f o re fractions. To enter fractions of
an inch, enter the numerator (value
above the line), press [ / ] (fraction bar
key) and then enter the denominator
(value below the line).
n u m e r a t o r 3
fraction bar —
d e n o m i n a t o r 1 6
For all other units of measurement, you
can only enter whole numbers or dec-
imal numbers. You cannot enter com-
binations of units (for example, you
cannot enter 12 meters 6 centimeters 4
m i l l i m e t e r s ) .
US I N G T H E
ULT R A ME A S U R E MA S T E R
U s e r ’s Guide – 2 9
To Next Page
Loading...
