Your metric-based plan says that the
bridge rail bolt must be tightened to 30
n-m but your torque wrench only
shows ft-lb. Find the ft-lb setting
re q u i red to set up the wre n c h .
S t e p s / K e y s t ro k e s D i s p l a y
1 . Clear Calculator.
[On/C] [On/C] 0 .
2 . Enter N-m :
30 [SHIFT] [9] 3 0 N-M
3 . Find ft/lbs:
[CONV] [SHIFT] [8] 22.12687 L B F E E T
5 6 – Ultra Measure Master
®
To Next Page
Loading...
