Calix BLAST u4g - Introduction

14
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
November 2022.
Introduction
This document describes the installation of the following:
 GigaSpire BLAST u4g
The BLAST u4g is designed to be placed flat on a table-top or wall mounted using the built
in mounting components as a guide.
Powering Options
 By attaching to any 110/220 VAC power outlet using the supplied 12 VDC wall
transformer.
Note: The power cord configuration must be appropriate for use in the country where
the u4g is being deployed.
Note: Only Calix provided and approved power cords or voltage adapters should be
used to connect to this product(s).
Tabletop or Wall Mount - u4g
u4g Power Supply