MEASUREMENT MODES
1. Standard - Standard Mode is recommended when measuring
distances to larger objects. (Fig. A)
2. P.A.T. (Pin Acquisition Technology) - P.A.T. Mode is best used
when measuring the distance to a agstick or smaller objects. To
toggle between Standard and P.A.T Mode, quickly PRESS the
Power Button Twice while device is powered on. When P.A.T.
Mode is activated, the agstick icon will appear on the left side of
the LCD display. (Fig. B)
3. Scanning - To measure distances to multiple targets in succession,
PRESS & RELEASE the Power Button to power on. Then HOLD
Power Button, the Laser Indicator Box will ash and the laser
will continuously re. Measurements will change as you scan the
landscape and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only
change when a shorter distance is measured. This is useful when
measuring the distance to a agstick when there are trees or other
objects in the background.
6 HOW TO USE
To Next Page
