MEASUREMENT MODES
1. Standard - Standard Mode is recommended when measuring
distances to larger objects. (Fig. A)
2.
6 HOW TO USE
P.A.T. with Pulse Technology - P.A.T. Mode is best used when
measuring the distance to a Flagstick or smaller objects. Device
will provide a short vibration to conrm that the laser has locked
on to the pin. To toggle between Standard and P.A.T Mode, quickly
PRESS the Power Button Twice while device is powered on.
When P.A.T. Mode is activated, the agstick icon will appear on
the left side and the Pulse icon will appear on the right side of the
LCD display. (Fig. B)
3. Scanning - To measure distances to multiple targets in succession,
PRESS & RELEASE the Power Button to power on. Then HOLD
Power Button, the Laser Indicator Box will ash and the laser
will continuously re. Measurements will change as you scan the
landscape and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only change
when a shorter distance is measured. This is useful when measuring the
distance to a agstick when there are trees or other objects in the background.
NOTE: To disable Pulse Technology but keep P.A.T. Mode activated,
start with the device powered o. Next, HOLD the Power Button for
5 seconds. The Pulse icon on the right side of the screen will ash &
turn o. To enable Pulse Technology again, repeat this process.
To Next Page
Loading...
