HOW TO USE 7
4. Unit of Measure - To change the unit of measure from Yards to
Meters, TOUCH & HOLD the top PowerPad
TM
until the unit turns
on. Then TOUCH & HOLD the MODE Pad on the left side grip
(MODE) until you see UNIT on the LCD Display. TOUCH & HOLD
the top PowerPad
TM
until you see the M switch to Y.
3. Scanning - To measure distances to multiple targets in
succession, TOUCH & HOLD the PowerPad
TM
to power on.
Then HOLD PowerPad
TM
, the Crosshairs will ash and the
laser will continuously re. Measurements will change as you
scan the landscape and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only
change when a shorter distance is measured. This is useful when
measuring the distance to a agstick when there are trees or other
objects in the background.
To Next Page
