ENGLISH 7
4. Slope Mode - Device will measure the angle of incline/decline (Fig. B)
then calculate and display the slope adjusted distance in the bottom
right of the LCD display. (Fig. C) To toggle Slope Mode on/o,
HOLD the Mode Button (M) down for 3 seconds.
5. Scanning - To measure distances to multiple targets in succession,
PRESS and RELEASE Power Button to power on. Then HOLD
Power Button, the Laser Indicator Box will ash and the laser
will continuously re. Measurements will change as you scan the
landscape and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only
change when a shorter distance is measured. This is useful when
measuring the distance to a agstick when there are trees or other
objects in the background.
6. Unit of Measure - To change the unit of measure from Yards
to Meters, PRESS Power Button to power on, then HOLD Mode
Button (M). The unit of measure is indicated by a “Y” or “M” shown
directly to the right of the distance displayed.
To Next Page
Loading...
