Introduction
Instruction Manual, Oct-16 3
use only (IP 20). Further, this device has passed the CAMAG Quality
Assurance tests and has been delivered in a safe operating condition. For
detailed instrument data see chapter technical data
• Attention: For safety reasons the instrument may only be used for the
purposes described in the operating manual
• To avoid injury use adequate safety equipment (protective goggles, gloves
etc.) when working with the instrument
• Before first operation, check whether the voltage shown on the instrument
matches your local mains voltage. The power cord may only be connected
to a grounded, fused (not higher than 16A) outlet. Do not use extension
cords without ground contact
• Risk of finger squeeze between moving parts; be careful closing the door
• The instrument may be used only by properly trained laboratory staff
• The instrument may not be used in rooms with danger of explosions
• The instrument contains highly sophisticated electronics and optical parts.
It may be operated only in a non-condensing atmosphere between 15 and
30° C (59 - 86 degrees Fahrenheit). Before installation and use, the
instrument should be acclimated properly
• Use a damp lint free cloth for cleaning the instrument surface. Do not
employ aggressive detergents
• Protect yourself and the instrument from electrostatic shock which can
cause damage to the electronic parts
• Only authorized personnel may open the instrument. Service and repair is
only to be performed by trained specialists. Use spare parts and
consumables supplied by CAMAG only. The warranty is voided if parts
from other sources are used. Check the service manual before you start
service to reduce product-specific risks
• The power cord has to be removed before the instrument is opened. It is
not permitted to work on an instrument that has been opened and is
connected to the power supply
• Spare fuses must be of the type specified by the instrument manufacturer.
It is forbidden to short-circuit or manipulate fuses
• If the instrument is found to be defective, it must be switched off and
steps must be taken to ensure that it cannot be switched on by mistake
• Carry out all safety checks and the preventive maintenance as
recommended by the manufacturer in order to assure your personal safety
and the full functionality of the instrument. Have an authorized service
specialist perform any service not described by this manual
To Next Page
Loading...