Introduction
Instruction Manual, Oct-16 4
• See original manufacturers' manuals for further safety data on third party
equipment supplied with the system
• Lift/move/transport the system with the necessary care (remove the glass
plate before transport, transport it only in the original packaging)
• The safety of any system incorporated with the equipment is the
responsibility of the assembler of the system
• This symbol indicates that this equipment must not be disposed of as
unsorted municipal waste but is to be collected separately as electrical and
electronic equipment (WEEE-Directive 2002/96/EC). To properly recycle the
instrument or parts of it you are requested to send the equipment back to
the distributor, producer or an adequate collection system at the end of its
life. This will have potential effects on the environment and human health
• When working with UV light, especially with short-wave UV light, be sure
to protect your eyes and skin from direct radiation, which inevitably causes
irritation and inflammation. Ordinary goggles provide protection, but it is
advisable to wear safety glasses or a face shield and gloves.
1.2 Parts supplied
CAMAG TLC Visualizer 2 basic comprising:
Part no
Description
Lens 12mm with NIR filter or
Lens 16mm with NIR filter
Accessories and spare parts
Part no Description
UV tube short wave (254nm) 8W, D=16mm, L=288mm
UV tube long wave(366nm) 8W, D=16mm, L=288mm
White light tube 8W, D=16, L=288mm
Spare UV 254 filter for side reflectors
Spare UV 366 filter for side reflectors
Spare glass for side reflectors
Filter support left complete
Filter support right complete
To Next Page
Loading...