⚫
Reorient or relocate the receiving antenna.
⚫
Increase the separation between the equipment and receiver.
⚫
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
⚫
Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE:
This module is intended for OEM integrator. This module is only FCC authorized for the specific rule parts listed
on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of certification. The final host product still requires
Part 15 Subpart B compliance testing with the modular transmitter installed.
Additional testing and certification may be necessary when multiple modules are used.
The host manufacturer should reference KDB Publication 996369 D04 Module Integration Guide.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 88cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-
frequency exposure guidelines for an uncontrolled environment can be satisfied.
The end user has to also be informed that any changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this equipment.
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The final end product must be labeled in a visible area with the following " Contains TX FCC ID: Z8H89FT0065 ".
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC MPE distance: 88 cm
IC Interference Statement
This radio transmitter [IC: 109W-0065] has been approved by Innovation, Science and Economic Development Canada to
operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in
this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this
device.
Le présent émetteur radio (IC: 109W-0065) a été approuvé par Innovation, Sciences et Développement économique
Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal d'antenne.
Les types d'antennes non inclus dans cette liste qui ont un gain supérieur au gain maximal indiqué pour tout type listé
To Next Page
Loading...
Need help?
General
