10
Remote control
Last updated: July 29, 2022 10:31. Revision #5462
The AXR100D is supplied with a remote control that operates this unit and its built-in tuner. In addition, the
buttons with Blue coloured icons can operate a matching AX CD player.
The supplied AAA batteries must be fitted before the remote control can be used
1. POWER BUTTON - Switches the unit between Standby mode and On.
2. MUTE - Mutes audio on the unit. Press again to cancel mute.
3. CD (BLUE COLOURED ICONS) - To operate the AXC players only. For more information refer to the AX CD
user’s manual.
4. SPEAKER A/B - Toggles between the selected loudspeaker terminals: speaker A only, speaker B only,
speaker A and B together, or all speakers off.
5. STEREO/MONO - Used only when FM is selected. Toggles between FM stereo output and FM mono output.
For low quality stereo FM signals, selecting mono can usually reduce the noise.
Note: Some FM stations are mono only, and selecting Stereo will have no effect on these.
6. MODE - Used for DAB/FM mode. Press to cycle the tuning mode between Preset, Auto, and Manual modes.
7. VOLUME - Increases or decreases the volume of the unit. Also used to change the bass, treble and balance
settings when these are selected.
8. SKIP/SCAN - Used when the DAB/FM tuner is selected.
In Preset mode – Steps up or down through the user-stored presets.
In Auto mode – Search for the previous or next available station with a strong signal.
In Manual mode – Adjusts the frequency in steps, for fine tuning.
9. MENU - This menu displays some system info, Tone setting, APD setting, Factory reset and Upgrade items.
Pressing a second time will return to the previous menu.
Use the volume buttons to change the level of the selected option.
10. PRESET BUTTONS (1/5, 2/6, 3/7, 4/8) - Used when FM or DAB is selected. These select user-stored station
presets.
Pressing a preset button once will select one of the first 4 presets.
Pressing and holding will select the later 4 presets.
8 presets are available directly from the remote, further presets can be selected in Preset mode by using the
Skip/Scan buttons.
11. SOURCE BUTTONS (D1, D2, D3, A1, A2, A3/Aux, Phono, DAB/FM) - Press the relevant button to select
the desired music source.
To Next Page
Loading...
Need help?
General
