CAME AGT V Installation Manual

󱤔
󱤕
M1
BOUT
M2
SW3
PROG
RESET
PROG
M2
SW3
PROG
PROG
<1’’
<1’’
>3’’
>3’’
<6’’
<6’’
M1
BOUT
SW3
PROG
RESET
PROG
M2
ROG
PROG
󱤖
M1
BOUT
SW3
PROG
RESET
PROG
M2
ROG
P
PROG
󱤗
󱤘
M1
BOUT
PROG
M1
BOUT
PROG
Page 14 - Manual FA01429-EN - 07/2020 - © CAME S.p.A. -The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Exiting programming. Press the PROG key briefl y 󱤔. The
PROG LED will switch o .
NOTE. If no action is performed, the procedure will end automat-
ically after 30 minutes.
Programming type of keys. When “Programming call keys”,
press and hold the PROG key 󱤕 for at least 3 seconds, then
release it (within 6 seconds) as soon as the PROG LED lights up
and the key backlighting fl ashes as shown in fi gure 󱤖, entering
the “Programming type of keys” procedure.
Press and hold the fi rst key on the entry panel in the position
shown 󱤗 until the LED backlighting stops fl ashing and remains
on 󱤘.
To exit programming once complete, press the PROG key briefl y
󱤔. The PROG LED will switch o .
If no action is performed, the procedure will end automatically
after 30 minutes.

CAME AGT V Specifications

General

Brand	CAME
Model	AGT V
Category	Intercom System
Language	English