CAME BRIDGE Series - Connecting Anti-Intrusion Devices; Safety and Maintenance; General Safety Instructions

10 11 1 2 3 4 EM 2 S1 S2
10 11 1 2 3 4 EM 2 S1 S2
+
-
Pag.
9
-
Manual code
:
119G3074
119 G3074 ver.
0.1
0.1 02/2009
© CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
Anti-intrusion photocell (N.C. contact)
Anti-intrusion sensors placed in line with the
passage way, activate a Buzzer, in case of any
climb-over attempts.
Anti-intrusion
sensor.
Photocell
Pressure sensor / (N.C. contact)
Anti-intrusion sensors placed under the turnsti-
le’s top cover, which activate the Buzzer, in case
of any climb-over attempts.
Photocell
Anti-intrusion
sensor.
Buzzer
Alarm buzzer activated by anti-intrusion devices
in case of any climb-over attempts.
Contact output: 12V D.C. – 100mA
9.4 Connecting optional anti-intrusion devices to the control panel
Do not allow children to play or loiter in the operating range of the turnstile.
Keep command and control devices out of reach of children, to prevent the turnstile from being accidentally activated.
Immediately suspend use of the turnstile if any anomalies are manifested.
Impact danger
Danger voltage running through
parts
Transit prohibited during operation.
Important general safety instructions
This product must be only used for its specific intended purpose. Any other use is wrongful and therefore dangerous. The manu-
facturer is not liable for any harm or damage caused by improper, wrongful or unreasonable use.
Warning: opening the turnstile only 60° will cause the tripod to automatically return.
Warning: by leaning on the tripod arm before it is released, the release will not take place and the turnstile will stay
closed.
10 Safety instruction
Once the power is connected, wait 10 seconds before proceeding with any operations.
Intelligent Security & Fire Ltd.