CAME BRIDGE Series - Installation Procedures; General Installation Guidelines; Tools and Equipment

EXIT
SWIMMING POOL
Pag.
3
-
Manual code
:
119G3074
119 G3074 ver.
0.1
0.1 02/2009
© CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
6 Installation
Make sure you have all the tools and materials needed to carry out the installation in total safety and in compliance with current
legislation. The figures shows examples of installers’ tools.
6.1 Tools and equipment
5 Application examples
Standard installation
Against the wall installation
Multiple installation
Platform installation
Warning: an exit fitted with a turnstile cannot be an emergency exit. There must always also be an emergency exit
for physically impaired persons.
Only skilled, qualified staff must perform the installation, in full compliance of the current legislation.
Before installing the automated device, please:
• Set up a proper omnipolar cut-off device, with contacts more than 3 mm apart, and power source isolation;
• Set up proper tubing and conduits for the electrical cables to go through with enough protection from any mechanical damage;
•
Check that any connections within the container (made to give continuity to the protection circuit) have additional isolation
compared to the other internal power conductors.
Intelligent Security & Fire Ltd.