CAME BX-243 - Installation: Mechanical Stops and Manual Release; Adjusting Mechanical Endstops; Manual Gearmotor Release Procedure

8
ENGLISH
The data and information shown in this dialogue may be changed by Came Cancelli Automatici S.p.A. at any time without prior warning.
5.7 Adjusting the mechanical stops
Adjusting the opening mechanical stops:
- with the motor in release mode, fully open the gate. Activate the opening-microswitch, turning the white cam counter-
clockwise. Secure the cam by turning the screw.
Adjusting the closing endstop:
- with the motor in release mode, fully close the gate. Activate the closing-microswitch, turning the red cam counter-clockwise.
Secure the cam by turning the screw.
5.6 Manually releasing the gearmotor
- insert the customised key and turn it couter-clockwise. Open the trap door and pull on the release lever.


Opening-microswitch
White cam
Closing-microswitch
Red cam