Page 7 - Manual FA01734-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
INSTALLAZIONE
The installation must be done by qualified, expert personnel and in compliance with the current laws.
Initial checks
Before installing the automation you must:
• make sure the gearmotor will be fixed where the it is protected from impact, and that the anchoring surface is solid and that the gearmotor
is fixed using suitable means (i.e. screws, bolts, etc.) to the surface;
• make sure you include a suitable omnipolar cut-off device, that features a distance of more than 3 mm among contacts, and that the power
is insulated.
• Connections within the case made for protection circuit continuity are allowed, as long as they are fitted with supplementary insulation
as compared to other internal conducting parts;
• Set up proper tubes and conduits for electrical cables to run through, and to guarantee protection from mechanical damage;
• Check that the door structure is robust enough, that the hinges are in proper working order and that there is no friction among fixed and
moving parts.
• Make sure there is a mechanical door jamb for both closing and opening.
Tools and equipment
Check that you have all the necessary tools and equipment, to carry out the installation in total safety, according to the current laws. The figure
shows an installer’s minimal equipment and tool requirements.
SECTIONAL DOORS SLIDING DOORS
FOLDING DOORS
To Next Page
Loading...
Need help?
General
