ENGLISH
ENGLISH
CAME cancelli automatici s.p.a.
Via Martiri della Libertà, 15
31030 Dosson di Casier
TREVISO - ITALY
www.came.it - info@came.it
WARNING!
Important instructions for the safety of people:
READ CAREFULLY!
Foreword
• U
se of the products must be restricted to its intended us
e
(
i.e. that for which it was expressly built for). Any other us
e is
t
o be considered dangerous. Came Cancelli Automatici S.p.A.
is not liable for any damage resulting from improper, wrongf
ul
o
r unreasonable use • Keep these warnings with the installa-
tion and use manuals issued with the automated system.
Before installing
(preliminary check: in case of a negative
outcome, do not proceed before having
complied with the safety obligations)
• M
ake sure that the parts you intend to automate ar
e in
go
od working order, and that they are properly balanced
and aligned. Also, make sure that proper mechanical stops
are already in place • If the operator will be installed
at a
height of les
s than 2.5 m from the ground or other access
level, check whether you will need any protections and/or
warnings • Any gate leaves, fi tted with pedestrian entrance
s,
o
nto which you will install an operator, must have a blocki
ng
me
chanism when the gate is in motion • Make sure that th
e
o
pening of the automated gate is not an entrapment hazard
as regards any surrounding fi xed parts • Do not mount th
e
opera
tor upside down or onto any elements that may fold
under its weight. If needed, add suitable reinforcement
s at
t
he points where it is secured • Do not install onto gates on
either an upward or downward slope (i.e. that are not on fl at
,
level gr
ound) • Check that any lawn watering devices will no
t
wet t
he gearmotor from the bottom up.
Installation
• C
arefully section off the entire site to prevent unauthorised
access, especially by minors and children • Be careful w
hen
handl
ing operators that weigh more than 20 Kg (see installa-
tion manual). In such cases, employ proper weight handling
safety equipment • All opening commands (e.g. button
s, key
s
electors, magnetic detectors, etc.) must be installed at least
1.85 m from the gate’s area of operation perimeter - or w
here
t
hey cannot be reached from the outside of the gate. Also
,
t
he direct commands (e.g. push button, or proximity device
s,
et
c.) must be installed at a height of at least 1.5 m and must
not be accessible to the public • All ‘maintained action’ com-
mands, must be placed where the moving gate leaves, transi
t
a
reas and driveways are completely visible • If missing, ap-
ply a permanent label that shows the position of the releas
e
me
chanism • Before delivering to the client, verify that th
e
syst
em is EN 12453 (impact test) standard compliant. Make
sure that the operator has been properly adjusted and that th
e
sa
fety and protection devices, as well as the manual release
are working properly • Where necessary and in plain sight,
apply the Warning Sings (e.g. gate plate).
Special instructions and
advice for users
• K
eep the gate’s area of operation clean and clear of an
y
o
bstacles. Trim any vegetation that may interfere with th
e
p
hotocells • Do not allow children to play with the fi xed com-
mand devices, or in the gate’s area of operation. Keep any
remote control devices (i.e. transmitters) away from the chil-
dren as well • Frequently check the system, to see whet
her
any ano
malies or signs of wear and tear appear on the mov
ing
p
arts, on the component parts, on the securing points, on th
e
c
ables and any accessible connections. Keep any joints (i.e
.
hinge
s) lubricated and clean, and do the same where fric-
tion may occur (i.e. slide rails) • Perform functional tests on
photocells and sensitive edges, every six months. Keep glass
panels constantly clean (use a slightly water-moistened cloth;
do not use solvents or any other chemical products) • If th
e
system
requires repairs or modifi cations, release the operator
and do not use it until safety conditions have been restored
• C
ut off the power supply before releasing the operator fo
r
ma
nual openings. See instructions • Users are FORBIDDE
N
t
o carry out ANY ACTIONS THAT THEY HAVE NOT BEEN
EXPRESSLY ASKED TO DO OR SO INDICATED in the manu-
als. Any repairs, modifi cations to the settings and extraor-
dinary maintenance MUST BE DONE BY THE TECHNICA
L
A
SSISTANCE STAFF • On the periodic maintenance log, no
te
d
own the checks you have done.
Special instructions and
advice for all
• Avo
id working near the hinges or moving mechanical part
s
• S
tay clear of the gate’s area of operation when in motio
n •
D
o not resist the direction of movement of the gate; th
is may
p
resent a safety hazard • At all times be extremely caref
ul
ab
out dangerous points that must be indicated by proper
pictograms and/or black and yellow stripes • When us
ing
a s
elector or command in ‘maintained action’ mode, keep
checking that there are no people in the area of operation of
the moving parts. Do this until you release the comma
nd •
T
he gate may move at any time without warning • Always cu
t
t
he power when cleaning performing maintenance.
EN
To Next Page
Loading...
Need help?
General
