10 11 E1 E6 Rx Tx 1 2 3 3P 4 5 7 CX CY
RX TX
./ # .#
10 11 E1 E6 Rx Tx 1 2 3 3P 4 5 7 CX CY
RX TX
10 11 E1 E6 Rx Tx 1 2 3 3P 4 5 7 CX CY
p.
15 - Manual code:
FA0 0132
-EN v.
2 08/2016
© CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without notice.
Photocells
DIR
Photocells
DELTA-S
Photocells
DELTA
Safety devices
Configure contact CX or CY (NC), input for safety devices such as
photocells, that are EN 12978 regulation compliant.
See CX input functions (Function F2) or CY (Function F3)-
C1 reopening while closing. When the boom is closing,
opening the contact causes its movement to invert until fully
opened;
C4 obstruction wait. Stopping the boom, if it is moving, with
resumption of movement after the obstruction is removed.
C5 immediate closing. Closing the boom after a vehicle has
passed through the operating area of the safety devices.
C9 immediate closing with obstruction wait when closing.
Closing the boom after a vehicle has passed through the
operating area of the safety devices.
During the closing phase, the devices also perform the
function of C4 obstruction wait.
If unused, contacts CX and CY should be deactivated
during programming.
Barrier indicator light (contact rated for: 24 V AC - 3 W max).
It warns of the barrier status, see function F 10.
Luminous cord (Contact rated for: 24 V AC - 32 W max).
If flashes during the boom's opening and closing phases, see function F 15.
Flashing dome light (Contact rated for: 24 V AC - 25 W max).
It flashes during the barrier's opening and closing phases.
Alternatively, it is possible to connect a cycle or courtesy lamp. (Contact rated
for: 24 V AC - 25 W max).
An auxiliary external light can be connected and placed anywhere to increase
lighting in the driveway.
Cycle: it stays on from the moment the boom starts opening until it is fully
closed (including the automatic closing time).
Courtesy: it stays on for and adjustable time of between 60 and 180 seconds.
Warning devices
To Next Page
Loading...
