CAME v6000 - Electrical Connection Details; Control Board Functions; Electrical Component Identification

󱵮
󱵯
p.
11
11 - Manual
FA00047-EN
FA00047-EN v.
2
2- 07/2016- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Moving the micro switch
Disconnect the cables of the micro switch and remove the latter.
NRemove the operator's cover and the gable brace. Pull out the electrical cable and fi t it through the hole.
Refi t the cable brace so as to block the hole.
Use a screwdriver to open up the predrilled hole for the electrical cables of the micro switch and fi r the cables
to the micro switch. Fit the micro switch to the operator.
Connect the connectors to the corresponding positions on the micro switch.
⚠ Reconnect the cables as originally connected (NO - C).
Fit the cover back onto the operator.