CAME V700E - Opening End-Stop and Test; Opening End-Stop Programming; Programming Verification Test

CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
LINE FUSE
1,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
N
CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
L
INE FUSE
1,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
E
FUSE
6
A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
N
E FUSE
1
,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
CL.SENS.
ZL56A
OP.SENS.
MOTOR FUSE
8A-F
2
1
ON
ACC. FUSE 3,15A-F
N
E FUSE
1
,6A-F
OPEN
OP / CL
AF
26V 17V 0V
MN
+
E-
ENC/RADIO
A.C.T.
SLOW.SENS
Pag.
15
15 -
Manual code
:
119EU87
119EU87
ver.
0.1
0.1
01
/
2009
© CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
...then press the ENC/RADIO button until the signalling led stays on for some seconds and then resumes blinking (the programming
operation is satisfactorily complete).
- Push and keep pressed the OPEN button until the door is fully open...
3 - Programming the end-stop in the opening phase
...then press the ENC/RADIO button until the signalling led stays on (the programming operations is satisfactorily complete).
Finally, set dip switch n°1 back to OFF.
TEST
Use the AP/CH button to command both an opening and a closing to verify whether the programming was successful.