CAMPAGNOLO EPS - EPS Power Unit Maintenance and Safety

COMPONENTS
MAINTENANCE - Rev. 01/ 06-2019 5
Check screws are tightened to
the correct torque
Torque
wrench
Check screws are tightened to
the correct torque
Torque
wrench
4 - EPS POWER UNIT
V1 POWER UNIT (11s)
V2 POWER UNIT (11s)
V3 INTERFACE UNIT (11s)
V4 INTERFACE UNIT (12s)
Since the EPS Power Unit contains the battery pack:
• Only use the battery charger supplied with the EPS driv-
etrain.
• do not dismantle or make any modifications to the EPS
Power Unit.
• do not use the EPS Power Unit if there is any visible
external damage to the unit itself.
• do no use the EPS Power Unit if damaged or malfunc-
tioning.
• keep the EPS Power Unit in a safe place, out of reach of
children and animals.
DANGER!
Do not heat or burn the power unit. Do not leave the
power unit in a place where the temperature may
exceed 60°C (e.g. in a car on a hot day or near fire-
places or heaters). Failure to observe these instruc-
tions may cause overheating, fire or explosion and
result in severe injury or death.
Before carrying out maintenance work on the electrical
components, the EPS drivetrain must be switched off:
- by inserting the magnet in the special seat on the under-
side of the Power Unit (version V1)
- by placing the special power off magnet in the "sensitive
area" on the Power Unit (version V2 / V3 / V4)