5.1.4 Test the connection
After the Network Map has been configured, test the cellular connection by using the Connect
screen as shown in the following image. Click on the appropriate station and click Connect to
initiate a call to the data logger.
TIP:
The connection time is subject to many external factors. It is often less than 30 seconds but
could be up to fifteen minutes. Be patient.
If the call is successful, the connectors at the bottom of the screen will come together and clock
information from the data logger will be displayed in the Station Date/Time field. If the
connection fails, a Communications Failure message will be displayed.
5.2 Modules using a public static IP
5.2.1 Configure RV50(X)
1. Download the collection of RV50(X) configuration templates from
www.campbellsci.com/downloads and run the executable downloaded.
2. Connect the Cellular antenna.
3. Connect the Diversity antenna, if used. Recommended but not required. Note: If a Diversity
antenna is not used, use ACEmanager to disable WAN/Cellular > Network Credentials >
RX Diversity.
RV50(X) Sierra Wireless AirLink® 4G LTE Cellular Modem 17
To Next Page
Loading...
