Table of contents
1. Introduction 1
2. Precautions 2
3. Initial inspection 2
4. Pre-installation 3
4.1 Establish cellular service 3
4.1.1 Campbell Scientific cellular data service 3
4.1.2 Other service providers 3
4.2 Install the SIM card 4
4.3 Konect PakBus Router setup 5
4.3.1 Get started 5
4.3.2 Set up Konect PakBus Router 6
5. QuickStart 8
5.1 Modules using Konect PakBus Router (private dynamic IP) 10
5.1.1 Configure RV50(X) 10
5.1.2 Enabling PPP mode 12
5.1.3 Set up LoggerNet 14
5.1.4 Test the connection 17
5.2 Modules using a public static IP 17
5.2.1 Configure RV50(X) 17
5.2.2 Enabling PPP mode 20
5.2.3 Set up LoggerNet 21
5.2.4 Test the connection 23
6. Specifications 24
7. Installation 25
7.1 Base station requirements 26
7.2 Data logger site equipment 26
7.2.1 RV50(X) mounting kit 28
7.2.1.1 Mounting the RV50(X) flat on the backplate 28
7.2.1.2 Mounting the RV50(X) on edge to the backplate 29
7.3 Wiring and connections 29
Table of Contents - iv
To Next Page
Loading...
