If connecting to Ethernet port:
Ethernet cable - connects the module to CR6 or NLxxx.
l Antenna — the following antennas are available from Campbell Scientific. Contact
Campbell Scientific for help in determining the best antennas for your application.
o
2 dBd 4G/3G Omnidirectional Antenna: An omnidirectional antenna with mounting
bracket that is ideally suited for use with 4G and 3G cellular gateways. The mounting
bracket attaches to a mast or crossarm, and it serves as the antenna ground plane.
The antenna has an N type (female) threaded permanent stud for easy mounting to
the included bracket or through an enclosure wall. A coaxial cable, sold separately, is
required to connect this antenna to the inline surge suppression or module antenna
jack. The antenna includes a mount/U-bolt assembly for attaching the antenna to a
mast, post, or crossarm up to 3.8 cm (1.5 in) in diameter.
o
8 dBd Yagi Wideband Antenna: A higher gain antenna that should be “aimed” at the
service provider antenna. It covers both the 800-MHz band and the 1.9-GHz band.
The antenna comes with bracket/U-bolt assembly for attaching the antenna to a
mast or post. A coaxial cable, sold separately, is required to connect this antenna to
the inline surge suppression or module antenna jack. This antenna is recommended
for areas that require a higher gain antenna.
o
4G/3G Cellular Whip Antenna with SMA Connector: A wideband termination
antenna with SMA connector and articulating base. It has a high-efficiency response
on nearly all 4G, 3G, and 2G frequency bands and is, therefore, primarily used with
cellular gateways and routers. This antenna attaches directly to the RV50(X) and is
RV50(X) Sierra Wireless AirLink® 4G LTE Cellular Modem 27
To Next Page
Loading...
