SETUP
rmo2013-001-011_a
1. Ad justm ent scre w
Low Beam
Insert a long Phillips screwdriver into air duct to
reach the adjustment screws.
rmr2008-027-106_a
1. Air duct
2. Screwdriver
Turn adjustment screws to adjust beam height.
Adjust both headlights evenly.
B.U.D.
S. Programming
Always
use the latest B.U.D.S. version on your
shop co
mputer. It is available from the following
web sit
e:
WWW.BOSSW E B.B RP.COM
Please note that the latest B.U.D.S. version is also
available in Info Center.
NOTICE
During data transfer, make sure that:
– Voltage (12V) remains stable before starting
update. Charge the battery or use a power
pack to ensure sufficient power reserve for
the procedure.
– Although the screen may ''freeze'' for a
while, B.U.D.S. continues to function in the
background.
– Never disconnect any cable while updating
the ECM.
MANDATORY TO
OLS
A personal computer (laptop or desktop)
MPI-2 INTERFACE CARD
(P/N 529 036
018)
MPI-2 DIAGN OS TIC CABLE
(P/N 710 000 851)
OPTIONAL TO
OL
Extension cable
available at electronic retail outlets.
Do not exceed 7.5 m (25 ft)
NOTE: B.U.D.S. can be used to program additional
keys (included keys are ready to use).
Use B.U.D.S. to
– Enter Customer's Name
– Reset Trip Hours and Trip Distances
– Reset Last Service
– Set Speedometer Units
– Check fault codes (if any).
Connecting PC to Vehicle
1. Remove service cover from vehicle.
2. Connect the PC to vehicle. Refer to the latest
edition of
CAN-AM ROADSTER B.U.D.S. SOFT-
WARE AND COMMUNICATION TOOLS
for the
proper connecting procedure.
3. Press READ DATA button from the tool bar to
initiate communication with the vehicle.
vmr2006-012-100_aen
36 / 41 2014-3 PREDELIVERY
To Next Page
Loading...
Need help?
General
