Installation, use and maintenance instruction manual ▪ Ed. 07/2018 Rev. 00
LIGHTING THE BURNERS
ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
The matching burner is indicated on each knob.
The burner can be lit:
▪ manually using the external igniter (on S versions),
▪ electronically with 12 V/DC generator (on E versions),
▪ piezoelectrically with mechanically/manually operated piezoelectric igniter (on P versions).
Proceed as follows to light the burner:
1
2
1 press the knob corresponding to the burner you
want to light and turn it anticlockwise (to the
maximum symbol).
2 Simultaneously, activate the electric (or
piezoelectric) lighting device with several fast
repeated pulses.
3 When lit, keep the knob pressed all the way for
another 5 seconds (at maximum) and then release
it, adjusting the desired intensity of the flame.
Please note: this delay in releasing the knob heats
up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple did not heat
up sufficiently. To solve this problem, repeat the operations described in the table, holding the knob down
longer after the burner is lit.
ATTENTION!
The burner must be lit without any pan or any other object on the hob unit above the burners.
To Next Page
Loading...
