4
28
Disarm/Alarms
Entry Delays
Similar to an exit delay, an entry delay is the time you are allowed
to enter the building, walk to the keypad, and enter a user code
before an alarm sounds. This delay lasts from 10 to 255 sec-
onds, depending upon your system's programming. The length
of the delay may differ, depending on which door you use.
During the entry delay, the Arm LED blinks. The keypad may
beep during the delay. If so, it buzzes during the last ten sec-
onds.
Disarming
To Disarm the System:
1. Enter through a door pro-
grammed with an entry delay.
2. Enter your user code.
Regardless of which method
was used to arm your system,
the disarming sequence is al-
ways the same.
Be sure that the door you use
to enter the building has been
programmed with an entry de-
lay.
To Next Page
