6
Maintenance
45
To Start a Remote Programming Session
If you have a monitoring station
hookup, your installer may be
able to program your security
system through the telephone
line. It is not necessary for a
technician to come to your
home or business to make
changes to your system.
At your installer's prompting,
you can initiate a remote pro-
gramming session by following
the directions to the right.
To Start A Remote
Programming Session:
1. Press and hold the
[walk test] key for 2 seconds
until you hear two beeps.
Enter the master user code.
2. Press the
key three
times until you see the fol-
lowing pattern of lit zone
LEDs:
1 2 3 4 5 6 7 8
3. Press the key.
The remote programming
session begins. Normally, a
remote programming session
takes just a few minutes.
To Next Page
