C&K systems System 238 - Changing User PINs (238;238 i)

24
User 1 can use his Master PIN to change the PINs of Users 1 - 8.
CHANGING A SYSTEM 238 AND 238i USER PIN
0
MASTER PIN
REQUIRED
.
#
*
*
.
#
#
If the new PIN is accepted, the keypad will beep twice. If you make a mistake while
programming, or if the system rejects the new PIN, the keypad will beep five times.
Enter the new PIN again and
push the # key.
The new PIN can be from two to five digits long, but must start with
the same first digit as the old PIN.
Enter the new PIN and push
the # key.
The READY, ARMED and SERVICE lights will
flash slowly to indicate programming mode.
Enter your Master PIN, push the
key, enter the digit "0", then
push the # key.