As required by UL Standard 1023, your alarm system is a Grade "A" system
(see definition on page 38).
Alarm system malfunctions and failures are caused most often by
INADEQUATE MAINTENANCE.
Your alarm system should be tested weekly to make sure that all detection
devices are working properly. In addition, if your system is being monitored,
you should periodically test its ability to transmit signals to our central station.
These tests should be performed weekly:
LOCAL SYSTEM TEST: Enter PIN (if required), then
.
6 0
#
*
.
CENTRAL STATION TEST: Enter PIN (if required), then
BELL/SIREN TEST: Enter PIN (if required), then
.
.
STANDBY BATTERY TEST:
6 1
#
*
Refer to pages 32-34 for further information on test procedures.
40
6 3
#
*
6 4
#
*
To Next Page
Loading...
