32
LOCAL SYSTEM TEST
This option allows on-site testing of each zone in your system.
Enter your PIN (if required),
push the key, enter the digit "6",
the digit "0", then push the # key.
Once the keypad lights go out, the system
will be ready for testing. Walk through the
areas protected by motion sensors; open and close protected doors and windows. Each
time a zone is faulted, its corresponding red ZONE light on the keypad will begin flashing,
and the keypad will chime.
PIN
REQUIRED
WARNING:Your alarm system will not report alarms during the LOCAL SYSTEM TEST.
.
*
To initiate the LOCAL SYSTEM TEST:
6 0
*
#
To exit the system test, push any key.
.
To Next Page
Loading...
