C&K systems System 238 - Changing User PINs (2316;2316 i)

27
User #1 can use the Master PIN to change the PINs of Users 1 - 32 (See Below).
CHANGING A SYSTEM 2316 AND 2316i USER PIN
NOTE: On System 2316i, User Code #32 is reserved for special functions using the
Optional Relay Output Module.
Enter your Master PIN, push the
key, enter the digit "0", then
push the # key.
*
0
MASTER PIN
REQUIRED
#
*
The READY, ARMED and SERVICE lights will
flash slowly to indicate programming mode.
.
Enter the User number (1 - 32) and push
the # key.
Enter the new PIN and push
the # key.
The new PIN can be from two to five digits long.
.
#
#
USER NUMBER