9
Make sure the green READY light is on.
If the READY light is not on, the red ZONE lights will indicate which zone(s) are faulted.
Faulted zones must be cleared or bypassed before the system can be armed. For more
information, refer to the sections Bypassing Zones and After An Alarm.
TO ARM THE SYSTEM:
.
Your PIN number can be from two to five digits long.
Don't pause for more than 5 seconds while entering the digits or the control panel will
reject your PIN number.
Enter your PIN and push the
# key.
.
.
PIN
REQUIRED
If you make a mistake while entering your PIN number, the keypad will beep five times.
After the fifth beep, enter your PIN number again.
.
#
To Next Page
Loading...
