EasyManuals Logo

Candy CDCP 6/E User Manual

Candy CDCP 6/E
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
12
When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Change the Programme...
Forget to Add a Dish?Forget to Add a Dish?
will keep on working after 10 seconds.
If you open the door when washing, the machine will pause. When you close the door , the machine
NOTE:
At the end of the Wash CycleAt the end of the Wash Cycle
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working,you can open the door
completely.
2
3
Open the door a little to stop the washing.
1
4
5
6
Premise:
Otherwise, the detergent may have already been
released, and the appliance may have already drained the wash water. If this
is the case, the detergent dispenser must be refilled (see the section entitled
" Loading the Detergent " ).
NOTE: If you open the door during washing, the machine will pause. When you
close the door and press the Button, the machine will keep on
working after 10 seconds.
The program lights show the state of the dishwasher:
Press S Button to pause the machine when the door is closed ,Press
Button more than three seconds the machine will be in stand by state ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . ." ).
S
a) One of the program lights on----------stand by or pause
b) One of the program lights blinking----- run
You can modify the washing program, When the dishwasher just
runs for a short time.
tart/Pause
tart/Pause
Program
Press the buttontart/PauseS
Press the button, the dishwasher will run
after 10 seconds.
tart/PauseS
WARNING!
It is dangerous to open the door when washing,
because the hot water may scald you.
If your model has broken remember function, the machine will go on to finish the selected
program after the power cut.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Candy CDCP 6/E and is the answer not in the manual?

Candy CDCP 6/E Specifications

General IconGeneral
Door colorWhite
Door hingeStandard
Control typeButtons
Product sizeCompact
Custom panel-ready-
Appliance placementCountertop
Lower basket safety stopYes
Upper basket adjustable heightNo
Cycle time195 min
Noise level51 dB
Drying systemCondensation
Delay start (max)8 h
Dishwashing programsEco, Quick
Left-on mode duration999 min
Number of place settings6 place settings
Number of washing programs6
Maximum hot water supply temperature60 °C
Current6 A
Power plug typeType F (CEE 7/4)
AC input voltage230 V
Energy efficiency scaleA to G
Power consumption (off)0.3 W
Power consumption (left-on)0.45 W
Water consumption per cycle7 L
Energy consumption per cycle0.62 kWh
Package depth605 mm
Package width555 mm
Package height503 mm
Package weight25000 g
Drying classA
Annual water consumption1960 L
Annual energy consumption174 kWh
Weight and Dimensions IconWeight and Dimensions
Depth500 mm
Width550 mm
Height438 mm
Weight21000 g

Related product manuals