Candy CDCP 6/E User Manual

normal for a small amount of water to come out of the salt container.It is
1
2
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the salt warning light may still be on even though the
salt container is filled.
If there is no salt warning light in the control panel (For some Models),you can judge when to load
the salt into the softener by the cycles that the dishwasher had run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Always use salt intended for use with dishwasher.
The salt container is located beneath the basket and should be filled as follows:
Attention!
Only use salt specifically designed for use in dishwashers! All other types of
salt not specifically designed for use in a dishwasher, especially table salt, will
damage the water softener. in case of damages caused by the use of unsuitable
salt the manufacturer does not give any warranty nor is liable for any caused
damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split,
remaining of the bottom of the machine for any period of time, which may cause
corrosion.
4
A. Loading the Salt Into the Softener
NOTE:
A Remove the basket and then unscrew and remove the cap from the salt container.
B Before first wash, add 1lt. of water in the salt container of your machine.
C Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
D After filling the container , screw the cap tightly back clockwise.
E Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled with
salt.
F Immediately after filling the salt into the salt container, a washing programme should be started
Otherwise filter system, pump or other important parts of the machine may be damaged by salty
water. It is out of warranty.
(Suggest choose rapid
program).
(Suggest choose rapid
program).
Open
NOTE:
If your model have water softener, you may skip this section.no
4. to
Prior using for the first time
4. to
Prior using for the first time
1 2
Step 1: Enter the status of salt adjustment
Adjusting Salt Consumption
Close the door, within 60 seconds after power on, press button and hold for 5 seconds,
the machine will enter setting mode.
Start/Pause

Candy CDCP 6/E Specifications

General

Door color	White
Door hinge	Standard
Control type	Buttons
Product size	Compact
Custom panel-ready	-
Appliance placement	Countertop
Lower basket safety stop	Yes
Upper basket adjustable height	No
Cycle time	195 min
Noise level	51 dB
Drying system	Condensation
Delay start (max)	8 h
Dishwashing programs	Eco, Quick
Left-on mode duration	999 min
Number of place settings	6 place settings
Number of washing programs	6
Maximum hot water supply temperature	60 °C
Current	6 A
Power plug type	Type F (CEE 7/4)
AC input voltage	230 V
Energy efficiency scale	A to G
Power consumption (off)	0.3 W
Power consumption (left-on)	0.45 W
Water consumption per cycle	7 L
Energy consumption per cycle	0.62 kWh
Package depth	605 mm
Package width	555 mm
Package height	503 mm
Package weight	25000 g
Drying class	A
Annual water consumption	1960 L
Annual energy consumption	174 kWh

Weight and Dimensions

Depth	500 mm
Width	550 mm
Height	438 mm
Weight	21000 g