Canon ae1 - Page 4

[8] Front lower extension cover
1 pc.
[8] Front lower extension cover
[9] Front lower extension stay
[lo] Caster cover
[l 11 Ground rail 1 PC. [l 11 Ground rail
[12] Screw (RS tightening; M3 x 8)
2
pcs. [12] Screw (RS tightening; M3 x 8)
[13] Screw (binding; M4 x 6)
6
pcs. [13] Screw (binding; M4 x 6)
[14] Screw (tapping; M4 x 12)
[15] Stepped screw (M4) 2 pcs. [15] Stepped screw (M4)
[16] Tray label
1 sheet [16] Tray label
[17] Settings label 1 sheet [17] Settings label
[18] Bookmaking label
[19] Rear foot cover
Buffer Pass Unit-E2
[I] Buffer pass unit 1 PC.
[2] Screw (tapping; M4 x 12)
2
pcs.
[3] Rubber sheet 1 PC.
[4] Blanking plate*1 1 PC.
[5] Screw (binding; M4 x 6)*l
2 pcs.
1 PC.
1 PC.
1 PC.
1 PC.
5 pcs.
6 pcs.
2 pcs.
2 pcs.
1 sheet
1 sheet
1 sheet
1 PC.
*': This part is used when only the finisher is installed. It is not used when a puncher unit is installed.